![]() ![]() I use the half splined wrench to hold the inner nut while I tighten the hose, and then just pull the half wrench away. This section also supports equipment sales by providing information about the scuba gear divers will. Executive Committee Dan Orr, Dan Orr Consulting, Chair Patrick Hammer, Dive Right In Scuba, Senior Vice Chair William Cline, Cline Group Advertising, Vice. My solution was to grind half of the splines off the inner wrench when I HAVE to use two. tools to engage divers and non-divers in the underwater. Curtis boss, Chuck Mitch- ell, said: Scuba was a tool and not some. A comprehensive range of scuba diving regulator accessories and parts are available from The Scuba Doctor. The double hose regulator dominated the diving scene in the 1950s and early 1960s. In the center is a round section on a threaded section that can be. The Atomic ST1 has a 5-port swivel turret 1st stage, 2 year service interval, and adjustable flow. The grade 316 stainless steel is twice as strong as brass and resistant to corrosion. The Sonar 1/4 inch NPT Male to Standard BCD Inflator Quick Disconnect adaptor fits many BCD inflator mechanisms. The S-210 has a solid section at the case that can be firmly clamped into a bench top vice. The Atomic ST1 is the ideal regulator for sport divers, built from solid stainless steel and titanium. Also, most aftermarket Scubapro wrenches are so thick that you can't get two next to each other on the G260. Sonar 1/4-inch NPT Male to Std Male Scuba BCD QD Adaptor. The other problem with trying to use two Scubapro wrenches is that to get the wrench off that's adjacent to the case, the splines have to align exactly, unless you're using the gray Scubapro tool. So like I said, if you have two wrenches great, but if both the hose and the nut come off, just gently screw the case nut back on, and attach your hose being careful to watch that the case nut doesn't further tighten when the hose meets the splined nut. ![]() Unfortunately, the plastic splined nuts found on the 195 will sometimes split with that much torque. The inner nut that attaches the barrel to the case should have slightly greater torque than the 40 in-lb that you use for the hose. With Scubapro, the key is differential torque. Our quality control makes us the best and ensures that you get the exact tool you paid for. W Meixner is perhaps thinking of older Aqualung or US Divers regs where the orifice is in the external nut. If you unscrew the hose and the splined nut comes with it, no big deal. Sorry, you don't need two wrenches with these two models.īoth the G260 and the R195 have captured barrels with square inserts into the reg body. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |